Machsupport Forum

Mach Discussion => Mach4 General Discussion => Topic started by: MitchB on November 03, 2015, 04:10:47 PM

Title: How do I get machine to stop for M6 manual tool change
Post by: MitchB on November 03, 2015, 04:10:47 PM

In Mach 3, there was configuration for this.  How do I do it in Mach 4? Thanks.

Title: Re: How do I get machine to stop for M6 manual tool change
Post by: MitchB on November 03, 2015, 05:25:33 PM

It looks like I should just insert M0 into the tool change G-code.  Unless there's a better way...

Title: Re: How do I get machine to stop for M6 manual tool change
Post by: dude1 on November 03, 2015, 05:54:46 PM

look in the macro folder it`s there