Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: finyl vinyl on October 21, 2015, 03:24:11 PM
-
hi, I am very new to Mach3 and CNC router, I have purchased a table top system and have down loaded mach3 I have gone through set up (twice actually as I uninstalled and started again) however I have a problem:
The DRO works perfectly whilst jogging however the table etc does not respond
I have watched the 3 videos on u tube and ensured that all appears correct, any ideas, my only thought is that the series cable is faulty?
Any ideas gratefully recieved
Paul
-
Are you using the parallel port? If so, what operating system?
Sounds like you have the wrong port address, a bad cable, or an OS that Mach3 won't work on (64 bit)?
-
Thanks Gerry, I have checked port address? I have 32 bit machine and can check a new cable tomorrow morning
I also gave an issue in the diagnostic screen in that the LEDs flash with the table turned on or off, is this possiblely related also?
Sorry to be needy but I am very frustrated
Regards
Paul