Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: cooter on October 18, 2015, 03:01:33 PM
-
Hello,
New member, fairly new to mach. Anyway, I am using Mach3 to run a plasma table and Sheetcam to generate my gcode. On thing that I have been unable to figure out is how to set the z-axis (torch height) between parts. If I have multiple parts (or times when the torch stops and moves before restarting) I would like to increase the height when it moves between cuts.
Can anyone tell me where I can set this? Is it in Mach or Sheetcam?
Thanks!
-
In Sheetcam goto Job Options and on the material page set the SET RAPID HEIGHT to whatever you want it to be.
(;-) TP
-
Awesome, I'll give that a shot!