Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Vojislav on October 16, 2015, 05:12:09 AM
-
Hello everyone ,
I have problem with converting dxf to nc. I have a lot projects made in tango pcb, in that program am able to export file like dxf, that dxf i load to nc plot to generate g code but dimensions are always a lot smaller than in tango. For a start i make square 100x100mm to make it simple. Is there something i didnt do right ?, Every advice is welcomed . Thanks !
-
My guess is that Tango PCB is exporting the dxf in the wrong units.
-
Tango PCB exports .dxf in imperial units. If your machine is set in metric units, be shure to add G20 at the beginning of your G code.
-
Ok, i will try is it work, thanks a lot !!!
-
Just to inform you that machine worked in real dimensions, thanks for helping !!!
-
You're welcome
Nema na čemu.