Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: robobass on October 08, 2015, 10:21:12 AM

Title: Cut time estimation?
Post by: robobass on October 08, 2015, 10:21:12 AM

I'm running Mach3 on a generic 3x router. Any way to calculate the running time of a program short of actually running it?

Title: Re: Cut time estimation?
Post by: jimthefish on October 08, 2015, 12:22:56 PM

Tool paths page, simulate program run

Title: Re: Cut time estimation?
Post by: robobass on October 08, 2015, 01:29:40 PM

Thanks!