Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: nico on October 03, 2015, 11:43:49 AM

Title: z axis not working
Post by: nico on October 03, 2015, 11:43:49 AM

hi all, all new to this , but have a problem with z axis, it only moves down, tried altering in ports and pins but no change, it worked fine on other days, am i doing something wrong or am i not doing something i should be.

Title: Re: z axis not working
Post by: DonMarkey on October 05, 2015, 07:22:51 AM

Loose dir wire?  Happened to me once.
Don

Title: Re: z axis not working
Post by: nico on October 18, 2015, 08:07:06 AM

ok, so what and where is the "dir wire"

Title: Re: z axis not working
Post by: DonMarkey on October 18, 2015, 09:06:05 AM

Direction wire. Either on the break out board or at the drive.
Don