Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: krisverheyen on May 04, 2007, 12:14:49 PM

Title: G100 servo and stepper
Post by: krisverheyen on May 04, 2007, 12:14:49 PM

Hello,
question about the G100 with mach3.
can i use for example 4 servo-motors and one stepper with this g-rex board?
thanks,
Kris.

Title: Re: G100 servo and stepper
Post by: Brian Barker on May 04, 2007, 03:58:04 PM

Yes, you need to have servo amps that take step and direction .. if you have that you are all set

Thanks
Brian