Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: mbwittig on May 03, 2007, 05:56:57 PM

Title: mach3 Artsoft rectangle at startup doesn't go away
Post by: mbwittig on May 03, 2007, 05:56:57 PM

Hello all,

The artsoft rectangle that shows at startup doesn't disappear, instead if covers the middle of the controls.  Anyone else have this problem?

-Mike

Title: Re: mach3 Artsoft rectangle at startup doesn't go away
Post by: ynneb on May 03, 2007, 06:55:07 PM

This sounds more like a video card issue than a mach issue. ( Not sure though)
You could try removing the picture from starting up. I think the picture is stored in the Mach folder.
All un tested just ideas.

Title: Re: mach3 Artsoft rectangle at startup doesn't go away
Post by: Brian Barker on May 03, 2007, 11:03:43 PM

Yup, that is a first :(