Machsupport Forum
Mach Discussion => Mach4 General Discussion => Topic started by: Pedio on August 30, 2015, 01:59:24 PM
-
The new version of mach4 (Mach4 mill screen set) cause the center wheel on the Shuttle Pro plug in to move at a very rapid rate. Is there any way to control this? The previous version of Mach (2580) had this moving at a very slow rate. I would use the outer wheel to get close and then the center wheel to fine tune. I have tried:
- changing the rapid rate slider
- Using the old shuttlepro plug in from 2580
- While in the shuttlepro programing mode moving the center wheel (this does not bring up the programming window for a button)
Thanks for any help / thoughts,
Peter
-
What is your incremental jog step size set at?
-
What is your incremental jog step size set at?
Not sure where I find the "incremental jog step size". Is it this table? If it is which one?
The only other place I know that controls the speed of the axis movement is on the motor set up tab. You can slow it down with the jog % slider on the screen set.
Thanks for the help,
Peter
-
Not sure where I find the "incremental jog step size". Is it this table? If it is which one?
Yes, all of them.
From the operation manual:
2.2.4 Jogging Tab
The jogging tab, figure 2-20, displays controls for jogging the machine’s axes and changing the jog mode.
Figure 2-20: Jogging Tab
Operator Control Selection: These are the tab markers. Select the desired tab by clicking on its name.
Jog Buttons: Buttons to jog X, Y, Z and A axes.
Cycle Incremental Jog Distance: In incremental jog mode each press of an axis jog button will move the machine on a specified distance, this button cycles through the distances defined in the general configuration. The current step distance in shown in the adjacent DRO.
Toggle Jog Mode: Toggles between continuous and incremental jog modes.
Jog Rate: Sets the velocity for continuous jog as a percentage of the machine’s max velocity.
Toggle Keyboard Jog: Turns on/off the ability to jog using the keyboard.
However, it could also be a setting in the shuttle pro plugin. Or a function of one of the shuttle pros buttons to alter the step size. I have only played with the shuttle pro briefly though so cant say for sure.
-
Thanks - that fixed it.