Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: akfalar on May 02, 2007, 04:11:54 PM
-
It looks like Mach will do this but could someone verify: can Mach 3 do waterjet ramping based on geometry?
Thanks so much,
AKFALAR
-
There is no set function for doing this, but it can be done with the accel/decel, by setting this to ramp up and down at a slow rate it is possible.
Graham.
-
Our current CAMsoft setup looks ahead for corners or circles of a tight diameter and based on the angular criteria it slows to accomodate. I saw someone else talking about look ahead functionality. Could you elaborate on this?
Thank you very much,
AKFALAR
-
We do that in the LazyCam for Plasma in circles ... and we could add it for small Arcs.
You could add that to the Galil plugin if you like...