Machsupport Forum

Third party software and hardware support forums. => Newfangled Mill Wizard => Topic started by: Bhohbein on August 27, 2015, 06:44:16 PM

Title: Stupid question.
Post by: Bhohbein on August 27, 2015, 06:44:16 PM
How to program an arc slot. I understand that start angle starts at 3 oclock and rotates ccw for the arc angle setting. But when i put my numbers in its not where i want them to be so i adjust the numbers and its not doing what i want it too. Anyone have an easy way to figure out where the arc should go. Or anyone have a problem like this.


Im cutting out rectangle blocks with keyway slots at the corners. Im trying to round the corners of the keyway slots if that makes any sence to you guys. Haha. Thanks for the help.
Title: Re: Stupid question.
Post by: Overloaded on August 27, 2015, 08:32:08 PM
Post a pic or dwg of what you are wanting to achieve.
I'm sure someone can help.

Russ
Title: Re: Stupid question.
Post by: BR549 on August 27, 2015, 10:57:39 PM
There seems to be some bugs in the newest version (;-) . I have not received an updated license yet so I cannot test it fully. But it gives some error messages that could not possibly be dealing with what I was doing testing wise.

(;-) TP