Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: catalyst on August 25, 2015, 04:35:04 PM

Title: Servo Motor question
Post by: catalyst on August 25, 2015, 04:35:04 PM

HI,

i have Adtech servo drive with motors (with brake) installed with 5 Axis brakeout board i have configured mach 3 but my motors not move any one please help

Title: Re: Servo Motor question
Post by: DMBGO on August 25, 2015, 07:18:12 PM

You need to provide a bit more detail here.
Tell us-
What type of motors
What type of servo controller
What type of BOB
How is the BOB connected to the computer
How is the BOB connected to the servo drive
Etc