Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: woodchuck60 on August 14, 2015, 10:12:17 AM
-
Newbie here, just got a 3040T with mach3. Mach3 would not install on my comp so i copied the Mach3 setup to my hard drive and then installed mach3. The problem is when I load a file to demo it doesn't show a pic on the job display, the file reads it is there but no display.
Am I supposed to buy a license? What am I missing? Thanks so much
-
If it loads G code but doesn't show the toolpath it means the tool path coordinates don't fall within the travels of the machine you have set up.
-
Is there an error message?
-
No error msg.
-
What should the toolpath coordinates be?
-
Make sure your not in table display mode, and regen the toolpath.
-
Double check to make sure that the toolpath is NOT disabled
-
I did both of those and it didn't work. It downloads the file but doesn't show up on display.