Machsupport Forum

Third party software and hardware support forums. => LazyTurn => Topic started by: Cam10000 on August 12, 2015, 08:11:20 PM

Title: lazyturn fine profile
Post by: Cam10000 on August 12, 2015, 08:11:20 PM

Need help.  When i create a rough profile on lazy turn it seems to work perfectly but when i add the fine profile that profile looks correct in lazyturn but the code cuts about twice as deep on the x.

Title: Re: lazyturn fine profile
Post by: Cam10000 on August 15, 2015, 11:40:06 AM

here is a picture of my file in mach3.  any help would be appreciated

Title: Re: lazyturn fine profile
Post by: Overloaded on August 15, 2015, 12:37:28 PM

You appear to be mixing Dia. and Rad. modes.
You must do everything in the same mode.
See the instructions by RICH in the docs. section.
Russ

Title: Re: lazyturn fine profile
Post by: Cam10000 on August 15, 2015, 01:08:09 PM

Thanks Russ, 

Title: Re: lazyturn fine profile
Post by: Cam10000 on August 15, 2015, 01:26:55 PM

dia mode vs rad mode.

Figured out my problem with help from Russ, but can't find in the manual how to fix this.  I see how to turn diameter mode on and off but not how to turn it on/off between rough or fine cuts.  When i uncheck diameter mode the program works fine but when in diameter mode the rough cut is correct but the fine cut is still in radius mode. is there a fix for this or do i just need to keep it in radius mode?

Thanks.

Title: Re: lazyturn fine profile
Post by: Overloaded on August 15, 2015, 07:35:17 PM

Look through this :
http://www.machsupport.com/forum/index.php/topic,20715.0.html
It might help.

Russ

Title: Re: lazyturn fine profile
Post by: Cam10000 on August 18, 2015, 06:29:41 PM

Thanks again Russ. 

Radius Mode it is.  Everything is working fine.