Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: markstk57 on August 11, 2015, 05:29:17 PM
-
I am still a newbie but learning fast. I have a problem. I use a dxf file in LazyCam and produce TAP file. The dimensions are accurate and show in Mach3 as x and y. So a 9"x9" part when I cut it comes out as 1.675"x1.675" Suggestions.
-
Post the dxf file.
Also post the .LCAM file.
Note that there is a Lazycam Manual and you should read it.
RICH