Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: makcnc on August 09, 2015, 08:38:51 PM
-
please help me of wiring and installing that thc to my cnc /mach3 plasma system
that does not need z axis but acts with torch uo / torch down signals and torch on
and there are some macro codes needed to be added to the post processor mm14/m15 m16/m17 m38/m39
this is the manual of it
http://www.purelogic.ru/files/downloads/doc/Controller/RichNC/SH-HC30_manual_Purelogic.pdf
please help
-
Hi
Did you get any joy on how to wire the height controller. I want to do the same thing with my plasma machine.
-
Hi All
Does any body have any experience in using the HS-HC30 height controller on how to make it work in Mach3. Z axis being replaced by height controller.
-
que tal excelente día yo tengo la respuesta creo un macro y un post procesador personalizado de acuerdo al thc que este instalado en su maquina el thc de microstep es un poco complicado pero ya he instalado varios
https://youtu.be/Z-zd6KijUN4