Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: DAS on August 09, 2015, 02:36:50 PM

Title: Step direction to +- 10 volts
Post by: DAS on August 09, 2015, 02:36:50 PM

Hi all

I know this has been asked before on older posts.  Most of the links are now dead and there must be a  better product out by now
have servo amplifiers that have a +- 10 volt input. Need to convert a step direction  from mach mill to the +-10 Volt to operate the servo amps.
used Skyco pixies on another project long time ago  but they are long gone  now.
any ideas what is the best.

Thanks  DAS

Title: Re: Step direction to +- 10 volts
Post by: ger21 on August 09, 2015, 02:58:09 PM

Larken makes the Step2Linear boards.
http://www.viperservo.com/

There are also a few motion controllers that can control analog servos. CS Labs, Vital Systems and Dynomotion all make them.