Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: dfurlano on April 29, 2007, 07:34:29 PM

Title: error
Post by: dfurlano on April 29, 2007, 07:34:29 PM

What does "Too fast for pulley.. Using Max" mean?

1.90.081

Thanks

Dan

Title: Re: error
Post by: chuckels on April 29, 2007, 09:12:46 PM

it means your G code is asking for a higher spindle speed than is set in your "config -- spindle pulleys" setting.
if your not using spindle control set this number to any high number -- maybe 20000
chuck"

Title: Re: error
Post by: dfurlano on April 29, 2007, 10:42:34 PM

Thanks.

Dan.