Machsupport Forum
Mach Discussion => Mach Screens => Topic started by: forrest on July 02, 2015, 12:25:27 AM
-
I installed the blue tooling screen and it looks good, but it only uses 3/4 of the screen, I had it installed on another computer and it filled the screen. I don't remember how I got it to fill the screen could some one lead me step by step how to change the settings to use the whole screen?
Thanks
Forrest
-
I had the subject screen set on an older and now defunct computer and it filled the screen. I installed it on the new computer and it works fine but it only fills about 3/4 of the computer screen. Could some one out there please instruct me step by step how to change the size of the software to use the entire screen?
Thank
Forrest
-
double click at the top it should make it expand
-
Go to general config, and check "Auto Screen Enlarge".
Then close and restart mach3.
-
My cnc will not go to home position in (Z axis when in blue screen) I know it must be to do with the probe but not sure