Machsupport Forum
Third party software and hardware support forums. => Mach3 and G-Rex => Topic started by: maxvw on June 30, 2015, 06:41:44 PM
-
Hello, I have built a plasma CNC controller to be used with a Hypertherm THC. the arc and Z axis is completely controlled by the Hypertherm unit.
What I need is an input that will not allow the cut to proceed until the hypertherm THC gives the go ahead. I have the torch on signal working but for some reason no matter what I do the cut resumes before the arc is ready.
Can anyone help me with this issue? I have tried using OEM Trig #1 but the system seems to ignore it even tho I can see if is working on the Diagnostics tab
thanks!
-
You need to use the ArcOK() signal in Mach3. Unless it goes active Mach3 will NOT move.
(;-) TP
-
Thanks I will give that a try in a minute :)
-
perfect that worked, the name THC ON was misleading haha thanks!