Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: scrambled on June 29, 2015, 01:42:30 PM
-
I turned on my flame table today, powered everything up, and pressed the red RESET button and the Y axis started to move on its own. I have not made any changes, or added any updates.
I am using Toms CandCNC BOB, and it has a LED for each axis and it flashes when Mach3 tells the axis to move. This LED for the Y axis is flashing, so Mach is telling the axis to move.
any idea where to start?
Steve
-
YEP, do you have the handpendant PN200 ???
(;-) TP
-
TP-
Good guess! I unplugged the pendant and the movement stopped.
When I plugged the pendant back in, it started to move again.
I use the probing routine to find the top of the plate. This is not working now either.
When the program runs, it goes to the first top of the plate z move, then scrolls to the end of the program fast.
the x and y axis move on their own very slowly.
could the plug in be corrupted ?
steve