Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Programinator on June 26, 2015, 02:19:59 PM
-
Hi, just wanted to know what the correct startup and shutdown sequence is. I am using uc-100 controller. Do i turn machine on then mach3 for startup and then for shutdown turn off mach3 and then machine?
Thanks
-
It doesn't matter in my opinion. I don't know anything about the uc-100.
RICH
-
Imo, the machine should not be powered up until Mach3 is running. And the machine should be powered off before Mach3 is closed.
-
I start up with the E-stop pressed, just in case a signal fires the plasma torch unexpectedly.
I generally just turn everything on and off but the E-Stop is always in before shutdown and startup.