Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: LerninCNC on June 22, 2015, 12:33:39 AM
-
Hi! I'm new to CNC and this forum. Been involved with manual machining my entire career (40+ years) but CNC has proven to be a new, and exciting, challenge. Now to my question. Why does the jog function randomly stop working? Pressing the Regen Toolpath, Rewind, Reset, and the Jog On/Off buttons sometimes gets jogging to work. There doesn't appear to be a particular button that gets the jog function back. Sometimes I have to restart Mach, or the computer. Could this be a noise issue or a configuration/setup problem.
Thanks
-
on some pages jogging does not work and under certin conditions it wont work until you hit stop
-
I'm on the Program Run screen when jogging stops working.
-
on some pages jogging does not work and under certin conditions it wont work until you hit stop
Hi I am in the same situation as LerninCNC jog randomly stops working and the tab key the does nothing, I am stumped,
-
My problem was due to electrical noise. After rerouting control wires away from power supply cables my problem went away.
-
Will try moving wire, thanks