Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Severance17 on April 26, 2007, 08:06:17 PM

Title: Cant figure out Mach2 Configuration for XS-3525/8S-4
Post by: Severance17 on April 26, 2007, 08:06:17 PM

I have a Taig mill with four axis controller (XS-3525/8S-4) and just purchased mach2 as sugested by the controllers web site but i cant seem to get the board to respond to any command sent to the board by the computer. i ust to use linux CNC which worked perfectly except you could only use one file type. so i switched to mach but now can not figure out how to get my machine up and running. if anyone could help with setup that would be great i have almost completed the users guide and didnt seem to help. any input would be appreicated.

Title: Re: Cant figure out Mach2 Configuration for XS-3525/8S-4
Post by: Hood on April 27, 2007, 11:45:44 AM

Scott, attach your xml file and someone will have a look and see if they can spot anything.
Hood

Title: Re: Cant figure out Mach2 Configuration for XS-3525/8S-4
Post by: Hood on April 27, 2007, 11:49:00 AM

BTW might be better with Mach3, its light years ahead of Mach2.
Hood