Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Leo Voisine on June 06, 2015, 09:11:27 AM
-
I was using Shuttle pro on my Mach3.
Great, but it was not reliable. I cleaned the insides a couple of times, and it worked for a while - but
ANYWAY - I bought a VistaCNC Mach3 pendant and installed the plugin.
I tries to disconnect the shuttle pro by clicking the green check mark to change it to a red X - but imediately get an error message and Mach3 shuts down.
How do I disable the shuttle pro?
-
Delete the plugin from the mach3\plugins folder.
-
Thanks GER
Does it matter if I just leave it in there and active? Will it be conflicting with my IMach MPG
-
If it's not causing problems, you can leave it.