Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Charlie_M on June 06, 2015, 07:14:36 AM
-
Hello everyone,
Setup a Job in the router yesterday things started off good and then went terribly wrong. I watched it for a while and things were working as they should so I left it to do some yard work. came back and to my horror I have holes where should be no holes and profiles all over the place. So Somewhere along the way I started loosing steps . I am using a hobbycnc pro driver board and I am running the latest version of Mach3 with the 2010 screen set. any ideas where to start to trouble shoot this? I checked the mechanics of the router first and all seems ok. Thanks.
Charlie
-
Was the machine running fine before or is this the first time you've used it?
-
Hi Gerry,
It seems that I have always had issues with missing steps. It was very small, until yesterday. I am talking it was off by a few inches.
-
What are your velocity and acceleration settings?
Ballscrew or rack and pinion?
-
I am using timing belt and pulley and my accel is 114 and velocity is 119 in per minute
-
Set your accels to 15 and see if that helps.
Is it a direct drive pulley on a belt?
-
Hi Gerry,
yes it is a direct drive pulley on a belt. its setup just like a Shapoko.