Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Cbyrdtopper on June 03, 2015, 08:41:32 AM
-
I have a 4 axis MPG pendant. I am using a brain to turn on Jog Mode ---> MPG when the MPG pendant is switched to any of the axis "X,Y,Z, or A"; respectively when I switch the MPG pendant to "OFF" the brain switches to Jog Mode ---> Cont.
I know this brain works because I am using it on 2 other machines. However, on this machine when I switch to an axis on the pendant it switches to MPG mode for a split second and switches back to Cont. When I manually hit tab and cycle through the jog modes it doesn't switch to MPG Mode. I have MPG 1 active in the ports and pins so it should at least toggle to MPG Mode but it is not.
Side note, I do not know what shuttle mode is, but whenever i enable it it switches to MPG mode but it will not allow me to use the MPG Wheel. ANY IDEAS???
-Chad
-
Learned what shuttle mode is. I am still not having any luck with this. I have a new XML and when I make the necessary changes to get the machine working the MPG still won't turn on inside mach 3.
-
SUCCESS!!! I have figured out the problem!! I am using a Pokeys board. Under the configure pokeys there is a check box on the bottom saying something about step and direction are needed to enable the MPG. I just turned it off and my pendant works again!!