Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: master_bebe on June 02, 2015, 12:17:43 AM
-
sometimes, when a problem is detected while milling, i have to stop the milling.
when pressing the ESC button, the spindle just stops and stays buried inside the material.
is there a way to make it move up (in Z) for 10-20mm automatically after pressing the ESC button ?
Sincerely, Guy.
-
Set up your safe Z setting to what you want.
(;-) TP
-
thanks. i appreciate it.