Machsupport Forum

G-Code, CAD, and CAM => LazyCam (Beta) => Topic started by: ftissera on April 24, 2007, 04:08:40 PM

Title: Offset problem
Post by: ftissera on April 24, 2007, 04:08:40 PM

Hello all,
Mach3 V2.00.65 and licensed LazycamPro

Two problems:
1) The offset corresponds to the diameter of the tool whereas it should correspond to the radius. 

2) Even problem for the internal pocketting, the internal pocket is too small of a 2*radius of tool. Just for the first offset, the remainder of the pocket is correct.

I had a pocket to make with a tool of 14mm I initially had to make an offset for a tool of D:7mm before making the pocket with the tool of D:14mm!

Could somebody check this problem?
Thank you in advance
Francis

Title: Re: Offset problem
Post by: Brian Barker on April 24, 2007, 11:11:05 PM

We know about the problem and will be fixed for the next release.

Thank you for telling us about it
Brian