Machsupport Forum

Mach Discussion => VB and the development of wizards => Topic started by: furkanyilmaz11 on May 23, 2015, 02:44:24 PM

Title: Brian Barker's THC Plugin
Post by: furkanyilmaz11 on May 23, 2015, 02:44:24 PM

Hi all,

Is there an any document or information about how to use and configure the THC plugin at the machsupport's plugin page?

Looking nice but I couldnt find the any document about plugin.

And how to use analog input for mach3? As I know Its impossible to use analog input from parallel port. And If its using modbus, what is the speed? Is there an anybody used this plugin?

Any suggests?

Thanks...