Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: nomis135 on May 18, 2015, 07:03:32 PM

Title: NEED HELP motor sound but no movement
Post by: nomis135 on May 18, 2015, 07:03:32 PM
Hello!
I'm building a controller with 3 single axis tb6560 drivers, the breakout board that came along and 24v 6.5 amps powersupply to control 3 nema 23 185oz/inch 2a

Every thing seems to be working but when i configured mach3 and tried to make the motors jog and the motors sound like they are moving but they aren't.

I'm thinking it might be a configuration that isn't right but i'm kinda new to cnc and don't know what to change.

If any info is missing let me know.

Thanks,
Simon
Title: Re: NEED HELP motor sound but no movement
Post by: Vogavt on May 18, 2015, 08:17:19 PM
Upload your xml file so we can take a look.
Title: Re: NEED HELP motor sound but no movement
Post by: nomis135 on May 18, 2015, 08:23:50 PM
xml file as asked.

Wish someone can help me as i've been on this all week-end.  >:D

Thanks,
Simon
Title: Re: NEED HELP motor sound but no movement
Post by: Vogavt on May 18, 2015, 09:11:53 PM
Looks like you're using the same pins for one of your axis and an output. Specifically pins 8 & 9.
I also see you have flood assigned to Pin 7 and Z-axis Dir pin as 7

Go back through the Ports & Pins and clean up the anomalies first.

Are you in Demo Mode?
Title: Re: NEED HELP motor sound but no movement
Post by: nomis135 on May 18, 2015, 09:22:25 PM
Yes, I am in demo mode for test purposes.
Title: Re: NEED HELP motor sound but no movement
Post by: nomis135 on May 18, 2015, 09:30:12 PM
i'm not too sure what you mean about pin 7 having flood assigned.

As posted earlier i'm kind of new and don't know much either about cnc.
Title: Re: NEED HELP motor sound but no movement
Post by: nomis135 on May 19, 2015, 06:17:10 PM
I cleaned out my anomalies.
But now all i'm getting is a sound when i jog but no movement.

I've been searching the web since yesterday to find a solution.

Still haven't found the solution.

Thanks in advance,
Simon

ps. cleaned profile loaded.
Title: Re: NEED HELP motor sound but no movement
Post by: nomis135 on May 20, 2015, 07:44:57 PM
nevermind find my problem was the 4pin wires that come along with they tb6560 driver.


Thanks.