Machsupport Forum
Mach Discussion => Brains Development => Topic started by: SSPW on May 13, 2015, 11:32:09 AM
-
Can somebody tell me which DRO number/name the feed rate set by gcode is?
I want the one with the arrow in the attached pic.
-
Probably 818.
-
:)
Maybe ?
Russ
-
I bet Gerry's right ... I see 818 in the list too.
Russ
-
I used list on the wiki too.
But, In my brain editor, i pick DRO, and 18 and 818 are not listed! Actually 18 is listed, but as G92A Z off!
-
Remember guys the DROs were revamped at one point to basically combine all the DROs (dro,oemdro,userdro) and all the old stuff is still there as well. Can be a big mess if you are not carefull.
Just a thought, (;-) TP
-
Good tip TP.
So then, for tha OP, where is the dro for use in a Brain ?
-
Ok! So a bunch of stuff is not listed under DRO.
But it has a "Use DRO Number" and says 1000-225 in valid
So i tried 818 anyways, and it works! LOL
BR549, i agree, Mach3 is a big mess, in terms of documentation!
You gotta be willing to search a lot more than you should have to, read a lot, here other places and watch a lot of youtube, and spend a crap load of time piecing the crumbs together to get a piece of bread!
-
ha ha, imagine that ! ... I tried that as well, posted the finding, then saw the 1000-2255 thing and deleted my post.
Then actually tried 818 anyway it it worked here as well !
At least we were on the same page lol.
Russ
Good job ! :)