Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: greenene on May 03, 2015, 03:25:53 PM

Title: how to make Z key command operative during operation
Post by: greenene on May 03, 2015, 03:25:53 PM
This is the result of upgrading Mach3 to a different version and losing some of my old functionalities. Specifically, the Z command is not responsive once I am in the middle of a program that has been executed. Sometimes, I need to make small tool depth offset changes and need to bring up the tool. Mach 3 now does not let me do it.  I know there's a way to do it, because I had been doing it for a long time.  Now I am stuck in the middle of a program, with the tool touching the stock.
I need to bring it up and need to know what, in Mach 3 config file, I need to check.