Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: oldnewbie on April 23, 2015, 05:21:14 PM
-
I just started running my new Marc3 and I need help. The XYZ dimensions don't add up. It shows 1.0000 but the actual travel is .10000. I need help on how to recalibrate so 1" is 1". Thanks Jerry
-
Hi Jerry,
Can you tell us about your setup? what step resolution is your drivers set up for? How do you drive the machine(ie lead screws or belts, rack and pinions )?
-
So you're off by a factor of 10.
Divide whatever your "steps per" setting is by 10.
Be sure to click SAVE and try it again.