Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: snowsp1 on April 20, 2015, 04:40:08 PM

Title: Why is the roadrunner milling the size of a dime?
Post by: snowsp1 on April 20, 2015, 04:40:08 PM
Why is the roadrunner milling the size of a dime?
Title: Re: Why is the roadrunner milling the size of a dime?
Post by: stirling on April 21, 2015, 04:12:42 AM
snowsp1 - I've split this into your own thread. To start your own topic just go to the sub forum you want to post in and hit the new topic button.

To your question: roadrunner assumes inch units. I suspect you're in mm. Either change units on the settings screen or better put a G20 at the top of the code.