Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Icarus_ENG on April 13, 2015, 05:53:48 AM
-
Hey guys!
I am using CreoElements to create my 3D models. I started using the same program
for creating G code. When I try to save the code I have to select post Processor.
Does it matter which one I select?
My CNC is an EBAY 3040 milling.
Thanking you in advance!
-
Hi,
I have a 3040 also and I would like what is the proper postprocessor to use
snowsp1
-
A Mach3 post processor, if there is one. Otherwise, try a generic g-code or generic fanuc.