Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Christine88 on April 12, 2015, 08:53:44 AM
-
So I'm using artcam express to generate G code for my shapeoko drawing CNC but it repeats very XYZ move. Can someone tell me what is causing this? It's taking twice as long to complete the drawing.
-
Sounds like an ArtCAM Express issue.
-
Sounds like an ArtCAM Express issue.
But I don't see any duplicate G code
-
Can you post the g-code?
-
Can you post the g-code?
Well after I went back and looked Artcam did generate duplicate code. So it is an Artcam issue apparently. So I needed figure out why.
-
I expect it is your tool stepdown in the toolpath. You havent set it to the depth to do in one pass
Gary
-
I expect it is your tool stepdown in the toolpath. You havent set it to the depth to do in one pass
Gary
That's what it is. Thanks!