Machsupport Forum

Mach Discussion => VB and the development of wizards => Topic started by: JTW on April 04, 2015, 08:23:13 PM

Title: Lathe turret ID and installation
Post by: JTW on April 04, 2015, 08:23:13 PM

I scored a nice turret on ebay but have no documentation or even a clue to the manufacturer. I think maybe Duplomatic or Pragati... Can someone with previous experience please provide a little guidance on how this needs to be set up and how the control of it should be performed? Thanks in advance!

(http://s18.postimg.org/xbxhxgplh/1425904326514.jpg) (http://postimg.org/image/xbxhxgplh/)

Title: Re: Lathe turret ID and installation
Post by: Cncman2nv on July 22, 2015, 11:41:52 PM

Did you get your turret going. looks like a nice one just checking if you still need help

Title: Re: Lathe turret ID and installation
Post by: JTW on July 25, 2015, 08:43:30 AM

Still need help. We were going to take it apart to reverse engineer it but time constraints from other work keep getting in the way. Also seems a waste of time if someone can just give us a wiring diagram. So nothing to report for now :)

We will not give up though!