Machsupport Forum
Third party software and hardware support forums. => CS-Lab => Topic started by: pitchblack on March 31, 2015, 05:33:44 PM
-
on the CSMIO/IP diagnostic window at the supply voltage -24 it says 119.85v in the display.
have check the supply voltage with a meter and getting just over 24 volts. anybody have any ideas why?
the 5 volt is fine and the cpu temp is at 37C which seems a little warm but really don't know
-
I have no idea why the voltage would display as such, mine display correctly on the two machines I have the CSMIO on.
Are you using an up to date plugin/firmware?
Hood
-
some thing must of happened with ip/a . had emailed cs lab about it and the said, send the controller back.
they are sending a new one out.
-
Ok, hopefully they will sort you out quickly :)
Hood