Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Bodini on April 19, 2007, 12:25:57 AM

Title: Too fast for pulley message
Post by: Bodini on April 19, 2007, 12:25:57 AM

Noob alert! ::)

What is this message I always get in the status line about, "Too fast for pulley..Using Max." ?

-Nick

Title: Re: Too fast for pulley message
Post by: Graham Waterworth on April 19, 2007, 02:01:37 AM

You have commanded a spindle speed over the max set in spindle pulley speeds.  Change the pulley speed in config and it will be ok.

Graham.

Title: Re: Too fast for pulley message
Post by: Bodini on April 19, 2007, 07:49:49 AM

Ok, I see.  Being a router user I didnt realize that was even there.  Thank you.  :)

Title: Re: Too fast for pulley message
Post by: MegaMoog on April 20, 2007, 10:08:00 PM

Problem is I change setting but it just keeps defaulting back to #4 at 8000 rpm?

What am I missing?

Thanks

Title: Re: Too fast for pulley message
Post by: Hood on April 21, 2007, 02:49:17 AM

Try setting it and saving then exiting Mach and restarting Mach again. If this doesnt help then  downloading the latest version of Mach might help.
Hood