Machsupport Forum
Third party software and hardware support forums. => Mach3 and G-Rex => Topic started by: vern howell on March 28, 2015, 05:58:05 PM
-
Hello,
I am trying to set up and use offsets. I created an offset by clicking the
"save workoffsets" tab an the bottom right of the offsets tab. I then
entered the coordinates of the location I wanted to use as an offset. I then
clicked "save". I ran the program several times and each time I ran the
program I clicked "goto zero" on the program homepage and the tool would go
to my offset as expected. However, when I turn the program off and return
the for the next session, when I click "goto zero" the tool goes to a
different location than the one I saved in the previous session. Can you
please help me out?
Thanks
Vern