Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Andy H on March 24, 2015, 06:42:38 PM
-
I am running Mach3 on my laptop (Windows7, 64) to control my Sherline Mill. All running well in my workshop.
Is there a way to run Mach3 without being connected to UC100 so that I can run it in my house? Doesn't want to reset at present.
-
Change the active state of the estop and it should reset.
Don't forget to change it back when at the machine.
Russ
-
Thanks Russ, now why didn't I think of that!
-
Hi Russ, eventually got round to trying your solution of disabling estop.
I can uncheck estop in 'ports & pins' and then 'apply'.
However when I go to check the active/disable state of estop, I see that it is still active with a green tick.
At this stage I still cannot reset.
Any ideas?
-
Change the active low setting, don't try to disable it.
-
Had already tried that with no effect.
-
Some developments!
Installed Mach3 on desktop pc and changing active low setting does allow me to reset.
So will be reinstalling Mach3 on laptop to hopefully get a duplicate result.
Thanks to all responders