Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: redpiperbob on March 18, 2015, 03:22:24 AM
-
Hi All
I hope you can help.
I am tying to use CNC Wrapper to wrap text. I create the text in CamBam and then open it in wrapper and i get a message arcs found wrapper disabled .
How can I get around this problem.
thanks
Bob
-
From the manual .........
Russ
:)
-
and ... same manual.
:)
-
Hi Russ
Thanks for the reply.
Do you have a link to the full manual I dont seemto be able to find one.
Thanks
Bob
-
Hi Bob,
I know it does not address your original question but you may want to take a look at Terry's wrapper wizard http://www.machsupport.com/forum/index.php/topic,23216.0.html
It does not have any problems with arcs, it's free and is just so simple to use. ;)
Tweakie.
-
Hi Russ
Do you have a link to the full manual ...............
Thanks
Bob
Go to where it was installed.
By default, mine was C, Program Files, CNCWrapper.
You should see the HELP file there.
Russ
:)
-
Thanks Russ
And Tweakie
Bob
-
Hi Bob,
I know it does not address your original question but you may want to take a look at Terry's wrapper wizard http://www.machsupport.com/forum/index.php/topic,23216.0.html
It does not have any problems with arcs, it's free and is just so simple to use. ;)
Tweakie.
Hi Tweakie ... and Terry (if you're listening),
I tried the TP Wrapper wizard but it doesn't seem to work for me (in sim).
I put the .set in a folder, then put that folder in Addons.
Wiz opens normally, enter info, returns to Mach, no wrappy.
Just Y moves, not A.
Where did I go wrong ?
Thanks,
Russ
-
Hi Russ, I have no idea but I am sure Terry will know.
(I incorporated the wizard into my 1024.set and it works just fine here).
Tweakie.
-
HIYA RUSS, DIDN'T Ya read the manual ??
Joking aside in SIM it will all look like you have Changed nothing. The Magic is in using the Y to drive the A. That way you have use of arcs which makes a very smooth function for A. The toolpath Screen will show it as a FLAT projection in XY BUT it will MACHINE around the A when used
DO you have a 4th axis setup and running ? And it still does not work ??
(;-) TP
-
Heya TP, no, I missed that manual. Was it in inglesh ?
Was just simming it on the desk, when there comes a time and I have the 4th, I'll definitely try it out.
Thanks guys,
Russ