Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: havingfun on March 15, 2015, 11:29:29 PM
-
When probing an edge using G31 I assume the probe must have some give so as not to damage the probe or edge before the motion stops. Typically how much give is needed? I'm using a Taig mill.
Any good plans to make one? If the amount of give is just a few thou might a short length of piano wire set in epoxy, or other insulating material, work?
Thanks
-
ftp://machsupport.com/ (ftp://machsupport.com/)
Broken link fixed