Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: quinchat on March 10, 2015, 07:36:57 PM
-
When Mach3 was shut down the tool offset for t3 was -.2162. When it was restarted the next day offset changed to -.1270.
What could cause this?
Quin
-
Is it the height offset in the tool table that is shifting?
Hood
-
Yes, it is the tool height.
Quin
-
Can you attach your xml and also your tools3.dat, and I will see if I can replicate the problem here.
You will have to zip them so the forum will accept.
Hood
-
Hood,
I'm getting some conflicting info from my operator so I'm suspending this thread until I get better info.
Thanks,
Quin