Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: paragon on March 08, 2015, 07:52:18 PM
-
Hi all....wondering if it is possible to add a ramp in move to post processor for gcode i am getting that does not have that feature....thanks
-
Normally the ramp will be defined in the actual CAM as you choose the toolpaths.
Hood
-
For example here is how it is set in BobCAD.
Hood
-
HEY Hood , just looking at your avitar. IS there NOT a Scotland any more ????? I have relatives from over there from about 10 generations ago.
(;-) TP
-
That is open to debate TP ;)
Hood
-
yes i have a seperate cam software but i also am usingcabinetpartspro which is nice for optimizing toolpathing etc...it just does not have the ramp feature, so I was trying to see if there was a way to insert via the post processor ?....thanks for any help
-
Afraid I do not know anything about Cabinate Pro or its post processor but think it unlikely you could do the ramp in the post processor.
Hood