Machsupport Forum

Third party software and hardware support forums. => Newfangled Mill Wizard => Topic started by: BR549 on February 28, 2015, 05:29:11 PM

Title: MilWiz bug ?
Post by: BR549 on February 28, 2015, 05:29:11 PM

HIYA Ron, I think I found a bug. When doing a circular hole pattern whith circle OR pocket I get this error. WHICH is wrong the values are correct. IF I use a -1.000 in the example I get this error IF I use +1.000 I also get an error that teh depth is greater than the Ztop which would be correct.

Title: Re: MilWiz bug ?
Post by: Ron Ginger on February 28, 2015, 07:59:18 PM

At a zero step depth it is going to take a lot of cycles to get to 1 inch.

Title: Re: MilWiz bug ?
Post by: BR549 on February 28, 2015, 08:54:26 PM

DUH, all I saw was PECK  and it did not seem to apply. And the message was about DEPTH so I missed it by a mile(;-)

Thanks (;-)TP