Machsupport Forum
Mach Discussion => Mach4 General Discussion => Topic started by: cnctom on February 28, 2015, 10:48:43 AM
-
Can someone help me with a dumb question in Mach4 with spindle cw I have my router set up on a ssr to pin 17 and im using Darwin to control Gecko G540 it all works as it should if i manually hit the spindle cw button in Mach4 it turns on and off as it should, but if i call up a M03 it doesn't work. I can call a M03 in MDI and the history says single sent to pin 17 but no happiness. But if I go and manually hit the spindle cw button in Mach4 it works. I've been reading the forums in Mach4 spindle search but can't figure it out.
Thanks for your time.
-
remove the M3, M4, M5 from the macro folder it should come right after that
-
daniellyall
;D Thank you very much that works great! I would have never found that I've been pulling my hair out for the last two days ;D.
-
be there done that