Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: andy_con on February 27, 2015, 06:07:40 PM
-
I want to store all my machining files on dropbox and then load them straight into mach3 from there. but it would seem mach3 doesn't work with dropbox
is there a way to get mach3 to work with dropbox?
-
If you don't want to have any problems, then you should only run g-code files from the local hard drive. Even running them from a flash drive can cause problems.
-
really?
I always run from a memory stick, never had a problem
-
Many people do have problems doing that. It's a known issue.