Machsupport Forum
Third party software and hardware support forums. => Modbus => Topic started by: Hurco on February 25, 2015, 10:57:02 AM
-
Hi,
I'm trying my first modbus setup and am having some trouble with addressing in Mach 3. I've attached a pdf from Yaskawa covering command and monitor registers.
I need help with the Mach 3 communication testing.
The GPD315 VFD RS-232 port defaults to 9600 baud, 8-n-1 and is fixed. My slave address is 1Fh.
How do I express my register values to Mach 3?
Thanks,
Hurco
-
Hi,
The Modbus Configuration Screen slave address drop down lists 0-10, but I can enter larger numbers. Do I enter decimal numbers and mach3 converts this to hex?
Thanks,
Hurco